Software Installation Step 1 | Network Configuration

Step 1.1:

To setup the static IP on your network port, click on Start and Run (or press Windows + R on the keyboard) and type in ncpa.cpl like below.

Step 1.2:

A Network Connections window will open. Right click the ethernet port that the motion is connected to and click on Properties.

Step 1.3:

Click on Internet Protocol Version 4 (TCP/IPv4) and select Properties. In the next window, select Use the following IP address: and type in 192.168.153.1 as your IP Address and 255.255.255.0 as your Subnet mask. Click on OK for both windows and ensure the network cable is connected between the computer and motion controller.